![]() ![]() You're right the light source looks like it is showing uniformly through the gap until the teeth, when the square is actually touching them. Maybe I'm just misinterpreting what I'm seeing. Only about 2 3/4 inches of the blade is visible above the surface of the table, so in order to check it without touching the teeth, I would need a square about 2 inches tall. ![]() Maybe the problem is that I am touching the teeth. I'm assuming that the lip is the same thickness throughout because I can't think of an accurate way to test it. Quick bevel lock with large scale for easy, accurate adjustments - Fence system provides 825 mm of rip capacity in a portable design for cutting large sheet. I held it against a factory edge and it passed the line test, but that really just proves that the top of the lip is square with the rest, not the bottom of the lip which is what it sits on when I just have it free-standing. As this is a metal gear, being pushed against by. Well.I'm using a speed square and that's a little hard to test exactly. This gear is resposible for raising and lowering the height of the blade by adjusting the height of the motor. It never occurred to me that a square might not be square. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |